Vertical View Angle Slider LECO

Just wanted to tweak a bit the view angle. The LECO ended up quite gentle and linear. I could train it further but i don't normally do big adjustment in the view angle, so I am fine with the granularity. If you wish to start higher or lower you can use From_Above and From_Below and do fine adjustments with the LECO.

For me it was stable from -5 to 5 I didn't have time to check further.

Until the XYZ plot was finished did i finally realize that i am dumb and you can't have a from_below angle for the on_back position because you would be inside the bed. :P

LECOs are manipulated by their weight and normally need no triggers to use it, change their weight like this <lora:AboveBelowView:-1> to lower the "camera" <lora:AboveBelowView:1> to Rise the camera. Remember you can go further than -1 or 1!