This workflow presets DREAMLAY and Experimental General N*** in Wan2.2 A14B FP8

LoRA

WAN DR34ML4Y - All-In-One N*** and (WAN 2.2 experimental) WAN General N*** model are pre-set. See the LoRA page for trigger words and sample prompts.

If you're having trouble with generation, first check the LoRA page and the reprint source, civitai, and check the following two points.

1. Have you forgotten to include the trigger word?

2. Are you using the appropriate image?

Image to Video only supports a limited number of poses and compositions.

Compare the image you're trying to use with examples of other users who have successfully generated it (only available on civitai) to ensure there are no problems.

LoRA Link

SeaArt(Reprint)

WAN DR34ML4Y - All-In-One N***

https://www.seaart.ai/models/detail/967ab3c20f9acfb7d0915f1d3606578f

(wan 2.2 experimental) WAN General N*** model

https://www.seaart.ai/models/detail/1e6336fc11d17dec8ee49e829970a33e

https://www.seaart.ai/models/detail/d27i3ple878c73cd9ge0

Civitai(Original)

WAN DR34ML4Y - All-In-One N***

https://civitai.com/models/1811313?modelVersionId=2303105

(wan 2.2 experimental) WAN General N*** model

https://civitai.com/models/1307155?modelVersionId=2083303

TIME COST

The generation time is approximately 2 to 3 minutes by default.

When using End image, generation time takes approximately 4 to 6 minutes.

Generation times may vary depending on the settings. Additionally, generation times may change during peak service periods. Please consider this time as an estimate only.

HOW TO USE

(1).LoRA

Three stacks, each capable of loading five LoRA modules, are connected.

One for High noise, one for Low noise, and one shared for both.

Wan2.2 primarily generates data using two samplers: High noise and Low noise. LoRAs are also available for High and Low noise, and both must be applied. Load the High noise LoRA into the High noise Stuck node, and load the Low noise LoRA into the Low noise Stuck node.

Load LoRAs for 2.1 that can be used in wan2.2, or LoRAs for 2.2 that are not divided into High/Low (like AIO), into the Share node.

(2).Prompt

Enter the prompt.

(3).Load Image

Upload an image to be the first frame of your video.

(4).Config

Set the video length (number of frames) and resolution (long side).

Videos are generated at 16 fps by default, so the number of frames is calculated as a multiple of 16. The default setting of 81 frames is approximately 5 times 16, or 5 seconds.

Set the resolution to the number of pixels on the long side. The resolution on the short side will be set to the original resolution to match the long side.

However, this value must be a multiple of 16.

If it is not a multiple of 16, you may see the error "RuntimeError: The size of tensor a..."

In this case, adjusting the aspect ratio of the ImageScaleByAspectRatio (FST) node to the scale factor closest to the loaded image may resolve the issue.

(5).End Image

Loads the image that will be the last frame of the video.

This function is off by default (Bypassed). To use it, press the switch on this node.

Once all the settings are complete, click the "Generate" button to begin generation.

That's it for now. Have fun!

萬 2.2 A14B FP8 I2V DR34ML4Y+實驗性一般N§ƑW

評分與評論